- No compressor — plug in and mill.
- Mills in pure water — no additives.
- ±20° A axis — undercuts without regrinding.
The P42 Plus makes wet milling simple. Without a compressor the installation is plug and play, the noise level lower and the number of parts that can break fewer. An open system that works with all ceramic blocks and all intraoral scanners. An inlay takes about 15 minutes, a crown about 25.
Key features
Clean water
No additives to dose or handle. Lower running costs and less waste.
±20° A axis
Undercuts are milled in the machine instead of being ground by hand. Better fit, fewer remakes.
Double-face nesting
Two veneers from the same block when the geometry allows.
Three material sizes at the same time
Mixed cases in the same run.
Open system
All ceramic blocks and all intraoral scanners.
Learned in a day
Touchscreen and guided workflow.
Licence-free software
Soreal and UPCAM are included with no annual fee. No license to renew and no subscription that grows over time.
Key figures
Axes4, with a ±20° A axis
Spindle800 W, up to 60,000 rpm
MachiningWet, clean water without additives
MaterialGlass ceramic, PMMA, composite and titanium
Dimensions564 × 564 × 402 mm
ConnectionWi-Fi, Ethernet and USB
Electrical100–240 V
Compressed airNot required
Milling timesInlay approx. 15 min, crown approx. 25 min
SoftwareSoreal and UPCAM included
Warranty1 year
Ready to produce from day one.
- Installation and fine-tuning on site by our technicians
- CAM software with no licence fee
- Starter kit of burs
- Support by phone, chat and remote control
- Our own workshop and spare parts in stock
Support agreement SEK 690/month excl. VAT – all machines at the same address. Included for Premium Partners.
About service and support →See the machine at work – for real.
Book a demo at our office in Nacka, at your place or at Swedental 11–13 November, booth B07:18.
Specifications
| Brand | UP3D |
Alternative Products
These other products might interest you